Running a full node

Save your Chain ID in dydxprotocold config

Save the chain-id. This will make it so you do not have to manually pass in the chain-id flag for every CLI command.

dydxprotocold config chain-id $CHAIN_ID

Getting a Snapshot

See snapshot service.

Start a Full Node

Find the seed node's ID and the IP address from Resources. Then, run the following command to start a non-validating full node.

For example,

dydxprotocold start --p2p.seeds="..." --bridge-daemon-eth-rpc-endpoint="<eth rpc endpoint>" --non-validating-full-node=true

💡Note: if you want to disable gRPC on your full node, it is important to start the node with the --non-validating-full-node=true flag. Otherwise, the application will require that gRPC be enabled.